Points To Note On Disassembly And Reassembly; Note On Locations Prohibited From Disassembly; Moving The Carriage Manually; Units Requiring Draining Of Ink - Canon iPF710 Service Manual

4.3 Points to Note on Disassembly and Reassembly

4.3.1 Note on locations prohibited from disassembly

Assemblies that are prohibited from disassembly and their adjustment outside the factory cannot be conducted
are indicated by red screws.
Don't never loosen or remove the red screw, because normal operation and print can't be done if it is loosened
or removed.

4.3.2 Moving the carriage manually

Move the carriage as required during disassembly/reassembly to prevent the carriage form contacting the parts
to be removed.
The carriage does not move when capped. When uncapping moving the carriage, refer to the procedures in
DISASSEMBLY/REASSEMBLY>Points to Note on Disassembly and Reassembly>Opening the Cap/Moving
the Wiper Unit.

4.3.3 Units requiring draining of ink

Before disassembling the units in the ink passage mentioned below, drain them of inks completely to prevent
their leakage.
For instructions on how to drain units of inks, see Disassembly/Reassembly > Tips on Disassembly/Reassembly
> Ink Drainage.
[1]Ink Tube Unit
See Disassembly/Reassembly > Tips on Disassembly/Reassembly > Ink Tube Unit.
[2]Carriage Unit/Head Holder
See Disassembly/Reassembly > Tips on Disassembly/Reassembly > Carriage unit.
F-4-3
Chapter 4
0012-6356
0012-6357
0012-6359
4-3