Residential Gateway - D-Link DSL-G2452DG User Manual

Section 4 - Configuration
Your DSL-G2452DG is equipped with a Gigabit Ethernet WAN port which can be used to
connect to the Internet. This port may be used to connect to other Ethernet based networks.
In order for your DSL-G2452DG to use Ethernet, you must configure the Ethernet Settings,
VLAN Settings, and your IPv4/IPv6 Settings.
WAN Access Type:
Select Residential Gateway to configure Ethernet connection
settings.
Interface:
Select the interface from the drop-down menu. ETH0-ETH5 are
available. The default is ETH0.
Enable Interface:
Select whether to enable or disable this interface.
VLAN Settings
VLAN Tagged:
Enable or disable VLAN tagging.
If you enabled VLAN Tagged, the following options are available:
VLAN ID:
Enter the VLAN ID. The value should be 0, or 0-4079.
VLAN Priority:
Enter the VLAN Priority from the default 0 (lowest) to 7 (highest).
Service Type:
Select a service type from the list. Choose from INTERNET, TR069,
INTERNET_TR069. This information should be provided by your ISP.
If you are configuring your connection manually and your ISP has not
specified this setting, selecting INTERNET is recommended.
Proceed to IPv4 Settings on page 32 or IPv6 Settings on page 37.
D-Link DSL-G2452DG User Manual

Residential Gateway

30