Installing A Cd/Dvd Drive - Dell WHL Owner's Manual

Installing a CD/DVD Drive

1 Follow the procedures in "Before You Begin" on page 69.
2 If you are installing a new drive, unpack the drive and prepare it for installation.
Check the documentation that accompanied the drive to verify that the drive is configured
for your computer. If you are installing an IDE drive, configure the drive for the cable select
setting.
3 Connect the new drive to the set of rails that are attached to the inside of the cover. If a set of
rails is not attached inside the computer cover, contact Dell (see
page 142
4 If you are installing a replacement drive and the new drive does not have the bracket rails
attached, remove the rails from the old drive by removing the two screws that secure each rail
to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with
the screw holes on the bracket rails and then inserting and tightening all four screws (two
screws on each rail).
5 Gently slide the drive into place until the tabs securely click into position.
6 Connect the power and data cables to the drive.
If you are adding a drive that has an audio cable, connect the audio cable to the audio
connector on the system board.
110
Removing and Installing Parts
).
Get other manuals https://www.bkmanuals.com
"Contacting Dell" on
drive
bracket rails (2)
screws (4)