W 500
Problem
Width of paint
spray cannot be
adjusted
Device does not
function
Paint in the
ventilating hose
Poor covering
capacity on the
wall
24. Technical Data
Max. viscosity:
Power source:
Power consumption:
Atomizing output:
Max. delivery rate
Double insulation:
Sound pressure level*:
Sound pressure output*
Oscillation level:
Air hose length:
Weight:
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Cause
•
Adjustment ring is not connected
to the peg on the air cap
•
Air screen is clogged up
•
Device overheated
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
Technical Data
3300 mPas
230 V
, 50 Hz
~
370 W
120 W
375 ml/min
80 dB (A); Uncertainty K = 4 dB
93 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
3.5 m
approx. 3.1 kg
Remedy
➞ Connect adjustment ring and
peg
➞ Disassemble and clean
➞ Unplug the power plug, let
the device cool down approx.
30 minutes, do not bend the
hose, check the air filter, do
not cover the intake slots
➞ Clean the diaphragm
➞ Replace the diaphragm
➞ The material you are spraying
should be at room temperature
➞ Cross spray (Fig. 10)
➞ Closer to the object
GB
31