C. Ringer Volume; D. Area Code - Cortelco 730901-TP2-27F Installation And Operating Instructions Manual

Cortelco 2.4ghz cordless caller id telephone with call waiting owner's manual installation and operating instructions 730901-tp2-27f
Table of Contents

Advertisement

Caller ID System Operation
6. Press the
button to return to the STANDBY mode.
/ VOICE MAIL
NOTE: The date and time will automatically set, if you have subscribed to the Caller ID
service from your local telephone company.

C. RINGER VOLUME

This function enables you to adjust the ringer volume from HI, LOW and OFF as
desired.
1. Press the
button and hold down.
/ VOICE MAIL
2. Press the TELEPHONE KEYPAD
3. Press the
/FLASH
button.
EDIT
4. Press the SCROLL UP
OR DOWN
suitable for your convenience. HI is the preset ringer volume.
5. Press and hold down the
/RE/PA
SAVE
6. Press the
button to return to STANDBY mode.
/ VOICE MAIL

D. AREA CODE

At any time during options programming of a home area code where 7-digit is used
for ease of call back, please use the following instructions if 10-digit numbers are used
in your area.
1. Press the
button and hold down.
/ VOICE MAIL
2. Press the TELEPHONE KEYPAD
3. Press the
button.
/FLASH
EDIT
button.
button to adjust the ringer volume
button.
button.
21
Getting Started
BASE UNIT
BASE UNIT
ANTENNA
TONE/PULSE
SELECT SWITCH
120VWALL
OUTLET
AC ADAPTOR
8. Install the BATTERY PACK by plugging it
into the BATTERY CONNECTOR inside the
BATTERY COMPARTMENT.
9. Place the BATTERY PACK inside the
BATTERY COMPARTMENT.
10.Slide the HANDSET BATTERY COMPART-
MENT COVER firmly into place in its closed
position.
11.IMPORTANT:Before initial use, charge the
HANDSET for 12 hours.
12.TONE/PULSE Select Switch:
A. If your home is equipped with a tone
dialing system, set the TONE/PULSE
select switch to the TONE position.
B. If you have a rotary dialing system, set
TONE/PULSE select switch to the
PULSE position.
C. If you are unsure which system you have,
set the TONE/PULSE select switch to the
TONE position. Press the
on the HANDSET to make a call. If the
call connects, leave the switch as is;
otherwise set to the PULSE position.
POWER-IN
CONNECTION
JACK
TELEPHONE LINE
CONNECTION
JACK
BATTERY PACK
BATTERY
CONNECTOR
B ATTERY
COMPARTMENT
button
6

Advertisement

Table of Contents
loading

Table of Contents