Toshiba RAS-25S4KVPG-ND Service Manual page 82

• For detaching the indoor unit from the installation
plate, pull the indoor unit toward you while pushing
its bottom up at the specified parts.
Push
Push
Fig. 10-3-22
INFORMATION
• The lower part of indoor unit may float, due to the
condition of piping and installer cannot fix it to the
installation plate. In that case, use the screws
provided to fix the indoor unit with the installation
plate.
• Especially when the pipes are pulled out to the
left side, the indoor unit must be screwed to the
installation plate.
8 8
Screw
<How to remove the air inlet grille>
1. Be careful open the air inlet grille until arm touch
the stopper of the front pane.
2. Push arms on left and right side to outward
direction then pull toward you to remove front
panel.
Front panel
Arm of the
air inlet grille
Push arm to outward direction
Air inlet grille
Front panel
Fig. 10-3-23
Press
(unhook)
Installation plate 1
Wall
Indoor unit
Screw
8
Screw
<How to install the air inlet grille>
1. Fit the left and right arms of the air inlet
grille to the slot holes onthe two sides of the
front panel and push in completely.
2. Close the air inlet grille.
Be sure to press the positions as indicated
by the arrow in order to attach the air inlet
grille to the indoor unit.
CAUTION
• The air inlet grille should be removed before
installing the indoor unit. To avoid damage
to the corner of the air inlet grille or the wall.
- 82 -
Fig. 10-3-24
Fig. 10-3-25