Table of Contents
Advertisement
5.
Insert the Z-fitting on the clutch cable into the hole on the tine
clutch control. Hook the "Z" end into the opening from the inside
to the outside as shown in Figure 4.
Z-fitting
Tine Clutch
Control
6.
Squeeze the tine clutch control inward. Insert the right end into
the hole on the right side of the upper handle. See Figure 5.
Clutch Control
ASSEMBLY
Clutch Cable
Figure 4
Figure 5
ADJUSTMENTS
Wheels
The tiller is shipped with the wheel adjusted such that the unit sits
level. Before tilling, the wheel must be raised. To do this, remove the
clevis and cotter pins, raise the wheel to the desired position, then
reattach pins to secure, Figure 6. For transporting the tiller, reverse the
steps to lower the wheel.
Cotter Pin
9
Clevis Pin
Figure 6
Advertisement
Table of Contents
