Craftsman C459-62204-1 Operator's Manual page 16

OIL SERVICE
• Check oil level regularly.
• Be sure correct oil level is maintained. Check every five hours or
daily before starting engine. See oil checking procedure in the
Operation section.
Oil Change
IMPORTANT: Be sure to check engine on a level surface with the
engine stopped. Drain the oil while the engine is still warm to assure
rapid and complete draining.
1. Remove all fuel from tank by running engine until it stops from
lack of fuel.
2. Remove drain plug and allow oil to drain into a suitable container.
See Figure 19.
WARNING
Before tipping engine or equipment to drain oil, drain fuel from tank by
running engine until fuel tank is empty.
3. Reinstall the drain plug and tighten it securely.
4. Refill with the recommended oil and check the oil level. Refer to
the Operation Section and follow the appropriate instructions for a
short or extended dipstick.
5. Reinstall the oil fill cap securely.
WARNING
Used motor oil may cause skin cancer if repeatedly left in contact with
the skin for prolonged periods. Although this is unlikely unless you
handle used oil on a daily basis, it is still advisable to thoroughly wash
your hands with soap and water as soon as possible after handling
used oil.
WARNING
Used oil is a hazardous waste product. Dispose of used oil properly
Do not discard with household waste. Check with your local authori-
ties or Sears Service Center for safe disposal/recycling facilities.
SERVICE & MAINTENANCE
Fuel Filter
Figure 18
Oil Fill Cap
Drain
Plug
Drain Plug (If
Accessible)
Cleaning the Engine
If the engine has been running, allow it to cool for at least half an hour
before cleaning. Periodically remove dirt build-up from the engine.
Clean around the muffler. Clean with a brush or compressed air.
Do not spray engine with water to clean because water could
contaminate fuel. Using a garden hose or pressure washing equip-
ment can also force water into the air cleaner or muffler opening.
Water in the air cleaner will soak the paper element, and water that
passes through the element or muffler can enter the cylinder, causing
damage.
DO NOT use non-detergent oil or 2-stroke engine oil. It could shorten
the engine's service life.
Accumulation of debris around muffler could cause a fire. Inspect and
clean before every use.
LUBRICATION
Transmission
The transmission is pre-lubricated and sealed at the factory. It requires
no maintenance. See an authorized service dealer for any service
issues.
Tine Shaft and Wheel Shaft
Remove tine assemblies and wheel and lubricate the tine shaft and
wheel shaft at least once a season.
16
* Extended
Dipstick Shown
Figure 19
CAUTION
CAUTION
WARNING