Using The Usb Port; Switching On The Display; Switching Off The Display; Using The Push Assist System - Bosch HERCULES E-Imperial I-F8 Operating Instructions Manual

6.12.4 Using the USB port

Notice
Any moisture which enters through the USB port
may trigger a short circuit in the display.
 Regularly check the position of the rubber
cover on the USB port and adjust it as
necessary.
The USB port can be used to operate external
devices which can be connected using a standard
micro A/micro B USB 2.0 cable.
 Open the protective flap on the USB port.
 Replace the protective flap after using the USB
port.

6.12.5 Switching on the display

 Press the On-Off button (display) once.
 The electric drive system is switched on.

6.12.6 Switching off the display

If the display is not inserted into the bracket, it will
switch off automatically after one minute to save
energy if no button is pressed.
 Press the On-Off button (display) once.
 The electric drive system is switched off.
MY20H02-12_1.0_12.06.2019

6.12.7 Using the push assist system

CAUTION
!
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the pedelec wheels are not in contact with
the ground when the push assist system is used
(e.g. when carrying the pedelec up stairs or when
placing it on a bicycle rack).
 Only use the push assist mode when pushing
the pedelec.
 You must steer the pedelec securely with both
hands when using push assist.
 Allow for enough freedom of movement for the
pedals
The push assist helps the rider to push the
pedelec. The speed can be a maximum of 6 km/h
in this case.

The tractive power of the push assist and its
speed can be influenced by the selection of gear.
To spare the drive, first gear is recommended for
travelling uphill.

The level of assistance O F F must not be
selected.
 Press the push assist button once to activate
the push assist.
 Press and hold the plus button within 3
seconds to switch on the push assist.
 Release the plus button to shut off the push
assist. The push assist system switches off
automatically as soon as the pedelec wheels
are blocked or the speed exceeds 6 km.

6.12.8 Using the riding light


The drive system needs to be already switched
on to turn on the riding light.
 Press the riding light button.
 The riding light is switched on (riding light
symbol is displayed) or switched off (riding
light symbol is not displayed).
Operation
82