Table of Contents
Advertisement
Push in the quick release until you hear a
clicking sound. Make sure that the flange is
extended.
Figure 41: Pushing the quick release in
Adjust the clamping with a half-open clamping
lever until the flange reaches the fork end.
Figure 42: Adjusting the clamping
Fully close the quick release. Check the quick
release to ensure it is firmly in place and adjust
on the flange if necessary.
The lever is secured.
Figure 43: Closing the quick release
MY20H02-12_1.0_12.06.2019
5.3.4
Mounting the wheel in the FOX fork
Only applies to pedelecs with this equipment
5.3.4.1 Wheel with quick release (15 mm)
The procedure for installing the 15 x 100 mm and
15 x 110 mm quick releases is the same.
Place the front wheel in the fork ends of the
fork. Push the axle through the fork end on the
non-drive side and hub.
Figure 44: Pushing the quick release in
Open the axle lever.
Turn the axle five to six complete revolutions
clockwise into the axle nut.
Close the quick release. The lever must be
tensioned to the point that it leaves a mark on
your hand.
The lever must be 1 to 20 mm ahead of the fork
leg in the closed position.
1-20 mm
Figure 45: Spacing between lever and fork leg
If the lever is tensioned too little or too much
when closed in the recommended position (1 to
20 mm ahead of the fork), the quick release
must be adjusted.
Assembly
49
Advertisement
Table of Contents
