Braun ThermoScan 6 Manual page 7

4 . Fully insert the IRT probe into the ear canal and point it
towards the opposite temple . Make sure the IRT is
pointed toward the ear drum and not the canal walls .
Once positioned correctly, press and release the start
button .
5 . ExacTemp Stability Indicator light will pulse while temperature measurement is in
progress . The light will remain solid for 3 seconds to indicate that a successful
temperature reading has been achieved .
NOTE: If the probe has been properly inserted into the ear canal during the
measurement, a long beep will sound to signal the completed measurement .
If the probe has NOT been constantly placed in a stable position in the ear
canal, a sequence of short beeps will sound, the ExacTemp Stability Indicator
light will go out and the display will show an error message
(POS = position error) .
See Errors and troubleshooting section for more information .
6 . The confirmation beep indicates that an accurate temperature measurement
has been taken . The result is shown on the display . Temperature reading
displayed is an equivalent of oral temperature .
To repeat
Go to step 3 .
7 . For the next measurement, press Eject button
remove, and discard used hygienic lens filter, and put on
a new, clean hygienic lens filter .
The Braun ThermoScan Ear thermometer turns off
automatically after 60 seconds of inactivity . The
thermometer can also be turned off by pressing the
Power button .
The display will briefly flash OFF and it will go blank .
to
English
5