Advertisement
DF/ED175-8V "K" Style Lid Kit Installation Instructions
3. Place two (2) sealing cap washers (item 9) over studs and two (2) nylon washers (item11), then fasten in place
with two (2) acorn nuts (item 8).
4. Set ice maker lid on the top of the dispenser.
5. Using the slotted holes in the lid as a template, drill four (4) 0.140" diameter (9/64") holes at the bottom of the slots
(see Detail A of Figure 1). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four
(4) #8 sheet metal screws, two on each side.
6. Seal the ice maker to the top of the dispenser as follows:
A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away the excess RTV.
7. Drill 9/64" diameter holes into the ice maker cabinet using the bracket as a template. Use extreme care not to drill
into any ice maker components (condenser, tubing, etc.). Secure the brackets using the screws provided.
8. Mount bin stat kit (item 17) as instructed except for the bin stat capillary tube mounting.
9. Pull 32" of capillary tube out of bottom of the ice maker. Slit and place vinyl tubing (item 16) over the capillary tube
leaving 6" of bare capillary tube exposed between capillary "S" bend and vinyl tubing.
10. Assemble two (2) nylon clamps (item 15) to the back side of the ice baffle (item 10) with two (2) screws (item 14)
and acorn nuts (item 8).
11. Route capillary tube around baffle as shown in Figure 2 and Figure 3.
12. Position two (2) nylon clamps (item 15) on studs of ice baffle (item 10) and two (2) nylon washers (item 11) on
studs as shown.
13. Place plastic insulation strip over the studs and insert baffle assembly into the bladder lid.
14. Place two (2) sealing washers (item 9) over studs and fasten in place with four (2) acorn nuts (item 8).
15. Route and form capillary as shown in Figure 2 and Figure 3. Tighten two (2) plastic clamps (8-32 X 3/8" screws)
to hold capillary tube in place.
16. Turn bin stat adjustment screw to the right (clockwise) until it stops, then, turn adjustment screw to the left (coun-
terclockwise) 1/8 turn. Verify the bin stat is working by holding ice on the bare capillary tube. The bin stat allows
the ice machine cycle to complete and harvest ice, then the machine shuts down.
17. If the acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to make small
notches in the cover to clear the acorn nuts.
NOTE: Bin thermostat must not interfere with the agitator rotation.
Publication Number: 620919507
Do not overtighten.
- 2 -
© 2000-2010, IMI Cornelius Inc.
Advertisement
