Panasonic KX-TGF973 Operating Instructions Manual page 64

Programming
you to easily monitor from different areas of
the house or even while away from home. The
monitored handset (placed in a baby's room,
for example) will automatically call the
monitoring handset, base unit, or the phone
number stored when it detects sound.
Important:
R Before using this feature, we recommend
that you test it and adjust the baby monitor
sensitivity as needed, especially if you plan
to monitor from outside.
R This feature should not be used as a
substitute for a medical or caregiver's
supervision. It is the caregiver's
responsibility to stay close enough to
handle any eventuality.
Note:
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored. If the base unit is
placed near the monitored handset, we
recommend turning off the base unit ringer
volume (page 60).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby's room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Handset
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select the desired unit's number to
monitor with. a MSAVEN
R "Baby monitor" will be displayed.
R The registered unit's name/number is
displayed.
For assistance, please visit http://shop.panasonic.com/support
64
KX-TGF97xUSA(en-us)_0928_ver121.pdf 64
Note:
R When this feature is on, another handset or
the base unit can hear the monitored
handset by making an intercom call.
To monitor from outside
If you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.
This feature is only available for landline.
Handset
n From the phonebook:
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select "Outgoing call" to
monitor from outside. a MADDN
4
MbN: "Phonebook" a MSELECTN
5
MbN: Select the phonebook entry. a
MSAVEN
R "Baby monitor" will be displayed.
Note:
R If you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
n By entering phone numbers:
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select "Outgoing call" to
monitor from outside. a MADDN
4
MbN: "Manual" a MSELECTN
5
Enter the desired name. a MOKN
6
Enter the desired number. a MOKN
a MSELECTN
R "Baby monitor" will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to "On".
9/28/2022 11:24:41 AM