Part 4: Operation; Speeds Lcd Touch Control - Philco PEI 62 Cube Owner's Manual

PART 4: OPERATION

4 speeds LCD Touch control

After plug in power, will into Stand By mode automatic.
Timer button
Time setting:
Keep pressing it when the machine is in stand by mode, it would start the time setting.
After pressing, the hour display would be flashing, you could press " " or " " to do the setting.
Press " " again, change to minute setting, press " " or " " to do the setting.
The third time press "
Timer setting:
Short press during working mode, pre-set cycle: off15mins30mins45mins60minsoff.
" " or " " is used for adjusting timer time, except "off" timer setting.
Quick timer: Press " " & " " hold for 3 second, the digital display will be flashing and starting the
5 minutes counting down. After 5 minutes working, the motor & light will turn off automatically &
Buzzer sound on.
Speed plus button
For increasing the speed of the fan. Totally 1-2-3-Turbo speed.
When the Turbo speed symbol appear, the motor reach the highest speed. After 5 minutes working
in Turbo mode, the motor would change to the Third speed automatically.
Speed decrease button
For decreasing the speed of the fan.
Light button
Short press for lamp power control.
The filter icons of the cooker hoods with display light up.
This icon lights up when the hood has reached 14 hours of operation or when it is first started.
The reset procedure is as follows:
• Turn on the hood light
• Start the engine, suction
• Long press the light icon until the full filter icon disappears from the display
LCD display
Copyright © 2018, Fast ČR, a. s.
" or wait 10s, the time setting would finish.
1. Motor symbol, will rotate when the motor is working;
2. Time display;
3. Timer symbol, will appear when timer is setting and counting;
4. Ligh symbol;
5. Motor speed;
6. Turbo speed symbol, will appear when the speed is highest setted;
7. Alarm symbol, will appear 5 seconds when the counting down of
timer is over.
8. Cleanning alarm, appear when total working time up to 14 hours or
at the first time using after pluging.
EN - 11
Revision 08/2018