Westinghouse iGen4500s Instruction Manual page 17

8. Generator Reset Button: Press and hold down
this button to reset the generator's electrical
output when safe to do so after reducing the
applied load or rectifying the electrical fault that
has caused an overload trip.
9. Data Center: The alphanumeric LED display
shows the cumulative run time, run time to
empty at current load, output power, fuel level
and output voltage in a repeating cycle. The
curved LED graphic displays on the left and
right-hand sides show the fuel level and output
power, respectively.
10. ECO Throttle Switch: Move the switch to the
ON position when powering small resistive loads
such as a computer or electric light; the engine
speed will automatically be kept to a minimum,
thereby reducing fuel consumption and noise.
Select the OFF position when powering large
inductive loads such as an air conditioner or
electric pump; the engine speed will be kept
higher for maximum electrical starting power.
11. Engine Control Switch: When the switch is
momentarily pressed to the START
position and then released to the AUTO RUN
position, the electric starter motor
automatically engages and starts the engine.
The engine will continue running whilst the
switch is in the AUTO RUN position. To stop the
engine, move the switch to the STOP position.
The engine can also be started and stopped
by remote control when the engine control
switch is in the AUTO RUN position.
12. Frame Terminal: The frame terminal can be used
by a licensed electrician to earth the generator if
necessary.
FEA TURES
12