BenQ DX832UST User Manual page 44

Function
Standby
Settings
Network
Settings
Reset All
Settings
44 Operation
Network
• Enable Network Standby Mode
Selecting On enables the function. The projector is able to provide
the network function in standby mode. Selecting Off disables the
function. The projector does not provide the network function in
standby mode.
• Auto Disable Network Standby Mode
Allows the projector to disable the network function after a set
period of time after it enters standby mode. For instance, if 20 min
is selected, the projector is able to provide the network function
for 20 minutes after it enters standby mode. When 20 minutes is
up, the projector enters normal standby mode.
This function is only available when Enable Network Standby Mode is
On.
Monitor Out
Selecting On enables the function. The projector can output a VGA
signal when it is in standby mode and the PC jack is correctly
connected to devices. See
the connection.
Audio Pass Through
Press / to choose the source that you wish to use in operation
mode. See "Connection" on page 16
When the corresponding jacks are correctly connected to the device,
the projector can output an audio signal to the external speaker when
it is in standby mode. The built-in speaker(s) will be muted in standby
mode.
Enabling this function slightly increases the standby power consumption.
Wired LAN
See BenQ Network Projector Operation Guide
AMX Device Discovery
When AMX Device Discovery is On, the projector can be detected by
AMX controller.
MAC Address
Displays the mac address of this projector.
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, User 1, User 2,
Reference Mode, 3D Color Management, Reset Picture Settings,
Projector Installation, Language, High Altitude Mode, Security
Settings, Baud Rate, Network Settings, Lamp Timer.
Description
"Connection" on page 16
for how to make the connection.
for how to make
for details.