Figure 7-2. Analog Output Grounding Example
1. Slide the cable through strain relief and tighten the compression fitting in
order to seal the cable.
2. Locate the screw and washer on the hole and tighten them enough to establish
a thread engagement.
3. Twist the grounding wire around the screw and under the washer.
4. Tighten the screw in order to secure the wire.
DTG-RTG100 Design for CE Conformity
GROUNDING
HARDWARE
SHIELD WIRE
(TWISTED
AROUND
HARDWARE)
ANALOG OUTPUT
CABLE (TX4)
7
7-2