Volvo V60 RECHARGE 2021 Owner's Manual page 467

Programming individual buttons
To program an individual HomeLink
1. Press and hold the desired button for
about 20 seconds.
2. When the indicator light on HomeLink
starts flashing slowly, it is possible to pro-
gram as usual.
Note: If the button you are reprogram-
ming does not program with a new
device, it will return to the previously
saved programming.
®
Resetting the HomeLink
It is only possible to reset all HomeLink
tons at once. It is not possible to reset individ-
ual buttons. Individual buttons can only be
reprogrammed.
Press and hold the outer buttons (1 and 3)
–
®
on HomeLink for about 10 seconds.
> When the indicator light goes from a
steady glow to flashing, the buttons
have been reset and are ready for
reprogramming.
Related information
®
• Using HomeLink * (p. 465)
®
• HomeLink * (p. 463)
• Type approval for HomeLink
17 Certain markets only.
Using HomeLink
®
button:
Once HomeLink
used instead of the separate remote controls.
Press and hold the programming button. The
garage door, gate, alarm system, etc. will be
®
activated (this may take several seconds). If
the button is held down for more than 20 sec-
onds, reprogramming will begin. The indicator
light will glow steadily or flash when the but-
ton has been pressed. The original remote
controls may be used concurrently with
®
HomeLink
buttons
NOTE
®
but-
When the ignition is switched off,
HomeLink
7 minutes.
NOTE
HomeLink
locked and the alarm is armed* from the
outside.
®
* (p. 466)
®
17
*
®
is programmed, it can be
if desired.
®
will be active for at least
®
cannot be used if the vehicle is
STARTING AND DRIVING
WARNING
®
• If you use HomeLink to open a garage
door or gate, be sure no one is near the
gate or door while it is in motion.
®
• Do not use HomeLink with any
garage door opener that lacks safety
stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982). A
garage door that cannot detect an
object - signaling the door to stop and
reverse - does not meet current U.S.
federal safety standards. For more
information, contact HomeLink at:
homelink.com.
Related information
®
• HomeLink * (p. 463)
®
• Programming HomeLink * (p. 463)
• Type approval for HomeLink
* Option/accessory.
®
* (p. 466)
465