Sherwood RX-4105 Operating Instructions Manual page 14

Select the desired preset number (1~30)
3
and press the MEMORY button.
• When using the NUMERIC buttons on the remote
control.
Examples) For "3" :
For "15" :
For "30" :
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is
stored automatically without pressing the MEMORY
button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If "MEMO" goes off, start again from the above step 2.
Tuning to preset stations
After selecting the tuner as an input
1
source, select the preset mode.
• Then "PRESET" lights up.
Listening to FM stereo broadcasts
• While listening to FM broadcasts,
• Each time this button is pressed,
the FM mode changes as follows:
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono mode
to reduce the noise, then FM broadcasts are
reproduced in monaural sound.
Repeat the above steps 1 to 3 to
4
memorize other stations.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
• INPUT SELECTOR settings
• Preset stations,etc.
Note
• If the electricity fails or the AC input cord is
disconnected for more than several days, they are
all cleared. So you should memorize them again.
Select the desired preset number.
2
• When using the NUMERIC buttons on the remote
control.
Examples) For "3" :
For "15" :
For "30" :
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
mode.
Scanning preset stations in sequence
• The receiver will start scanning the stations in the
preset sequence.
• At the desired station, press this button again to stop
scanning.
13