Sherwood RD-6105 User Manual page 17

Adjusting each channel level
Select the desired channel.
• Each time this button is pressed, the corresponding
channel is selected and displayed for 3 seconds as
follows;
Front Left Center Front Right
(Dolby Digital or DTS L(FE) )SubWoofer
( ): Adjustable only when the digital signals from Dolby Digital or DTS
program source that includes LFE signal are input in the available
surround mode.
• When it is in the stereo, or the speaker setting is "N",
center, rear or subwoofer channel will not be selected.
Adjusting each channel level with test
tone
• Only when it is in available surround modes except
stereo mode, the volume level of each channel can
be adjusted easily with the test tone function.
Note: When the 6 CH DIRECT is selected as an
input source, the test tone function does not
work.
Enter the test tone mode.
POWER DISPLAY SLEEP VIDEO1
1 2 3 VIDEO2
4 5 6 VIDEO3
7 8 9
T.TONE
T.TONE 0 P.SCAN TUNER
DSP MODE D.TIME ADJUST
AUTO CH. SEL MUTE T.MON
CH. LEVEL MASTER VOLUME
REMOTE CONTROL UNIT RM-105
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows;
Front Left Center Front Right
SUBwoofer Rear Left
• When the speaker setting is "N", the test tone of the
corresponding channel is not available.
• When the selected decoding mode is not matched to the
input signal format, the test tone function cannot work.
• The LFE level can be adjusted within the range of
• In general, we recommend the LFE level to be
Rear Right
Rear Left
• If the channel display disappears, start from the above
• You can select the desired channel and adjust its level
CD
AUX
Rear Right
1 8
Adjust the level of the selected channel
as desired.
10~0 dB and other channel levels within the range of
-15~+15 dB.
adjusted to 0 dB. (However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seems too high, lower the setting
as necessary.
step 11 again.
Repeat the above steps 11 and 12 to
adjust other channel levels.
At each channel, adjust the level as desired
until the sound level of each speaker is
heard to be equally loud.
with repeating the steps 11 and 12 in "Adjusting each
channel level" procedure.
Cancel the test tone function.
POWER DISPLAY SLEEP VIDEO1
1 2 3 VIDEO2
4 5 6 VIDEO3
7 8 9 CD
T.TONE
T.TONE 0 P.SCAN TUNER
DSP MODE D.TIME ADJUST AUX
AUTO CH. SEL MUTE T.MON
CH. LEVEL MASTER VOLUME
REMOTE CONTROL UNIT RM-105
-