Cornelius Flavorfusion TP01070 Training Manual page 20

FlavorFusion® Training Manual
Symptom
Blown fuse or circuit
breaker
Agitator does not
turn
Ice dispenses
continuously
Slushy ice or water
in hopper
Beverage does not
dispense
Beverage is too
sweet
Publication Number: TP01070
Dispenser Troubleshooting
Cause
Short circuit in electrical wiring
Inoperable agitator motor (shorted
motor)
No power
Improperly installed upper ice chute
assembly (Reed switch is not being
activated)
Inoperable reed switch
Electrical board driver circuit is
defective
Gear motor has open circuit
Reed switch is not activated Improper
assembly of upper ice chute to lower
chute.
Broken wire in the 2-wire harness
leading to the reed switch
Bad connection at main control board,
J3, pins 2 &3
Ice gate mechanism is stuck in open
position
Stuck or bent ice lever (does not allow
gate to close and open reed switch)
Blocked drains in cold plate
Poor ice quality due to water quality or
ice maker problems
No 24VAC to valves
No CO pressure
2
Valve brix requires adjustment
Carbonator is not operating
No CO in carbonator
2
Repair Wiring
Replace gear motor
Restore power or plug in unit
Check the upper ice chute assembly for
proper assembly and operation
Replace reed switch
Replace main control board
Replace gear motor
Check to make sure tongue of upper
chute engages into the back of the
lower chute, ensure upper chute
engages outside the lower chute, and
snap front of chute into place.
Repair of replace 2-wire harness
Repair connection or replace 2-wire
harness
Inspect gasket for proper position.
Examine gate plate to see if it slides
freely behind the lower ice chute.
Examine ice dispense lever to see if it is
bent.
Remove access covers in cold plate
cover & inspect/clean drains
Correct water quality or repair ice maker
Restore 24 VAC to valves
Restore CO
Adjust valve brix
Repair carbonator
Restore CO
- 16 -
Remedy
pressure
2
pressure in carbonator
2
© 2004-2007, IMI Cornelius Inc.