Advertisement
INPUTS (5)
Two input channels are provided. The line-level input is of the medium impedance balanced type. The jack is a
combo female XLR and 1/4" TRS connector. Sensitivity of this input is 0.42 volts for full output, when the MIC/
LINE switch (7) is in the LINE position.
Channel 2 has a 3.5 mm input jack for mobile device signal sources.
GAIN CONTROLS (6), Present on both input Ch 1 and input Ch 2
Controls the gain or output level of the same numbered input channel. It is used to directly set the system output
level for a given input signal.
MIC/LINE switch (7), Present on both input Ch 1 and input Ch 2
Switches between LINE level gain (out position) and MIC level gain (in position). MIC position increases gain
26 dB to allow use of most dynamic microphones.
NOTE: Phantom power is not supplied on the INPUT (5) jacks
Gnd LIFT switch (8)
Allows the shield to be disconnected from the chassis ground to alleviate hum from ground loops
DIRECT THRU output jack (9)
This jack is intended for the use of linking multiple SP®2P's in a line,
or to provide a feed to a powered subwoofer, or other electronics that needs to receive a full range version of the
input signal.
DIR/MIX switch (10)
Switches between Direct Thru from channel 1 input, or a mix of channel 1 and channel 2 at the Direct Thru out-
put (9)
SUB WOOFER PROCESSED output jack (11)
Provides a filtered signal for use with powered Sub woofer speaker systems other than the SP®118P or SP®218P.
Follow the instructions in the Setup Wizard in the SP®2P menu on the LCD screen using the Push-To-Select
button for proper subwoofer set-up and connection.
LCD Display (12)
Provides a menu read-out manipulated and activated by the Push-To-Select button (13)
Push-To-Select button (13)
Rotary knob that allow the user to select and choose menu options on the LCD display screen (12). Pushing the
button in till it detents makes a menu choice, selecting the action or option highlighted in the LCD screen.
Advertisement
