Advertisement
Distorted or Fuzzy Sound
First, ensure the mixer (signal source) is not clipping or being overdriven. Make sure the Gain (6) control on the
SP®2P has not been set too low. Check that the input plug is fully seated in the input jack on the rear panel of
the SP®2P. Ensure that a power amp has not been plugged into the input jack of the SP®2P. If an extension cord
is being used to provide the AC power to the unit, insure that it is of sufficient current capacity and that it is not
also being used to supply power to any other device.
The SP®2P has built-in EQ to smooth and extend the natural response of the speakers. If excessive additional
bass boost or HF boost have been added externally to the SP®2P, it could cause premature overload at high SPL.
Reduce the amount of any external (mixer, rack) EQ and see if that clears up the distortion.
If no external bass boost or HF boost has been added, but there seems to be an excessive amount of bass boost
(boominess, bass clipping, and/or treble boost (shrillness, sizzle, harshness), then you may have selected the
wrong choice on the Set-Up Wizard in the DSP menu on the LCD display. Go back and select the proper choice,
If using the SP Sub as the main input from the mixer, and then running a cable from the Sub to the SP®2P , then
the SP®2P should be set to USE WITH SP SUB on the Set-Up Wizard menu.
If the Set-Up Wizard menu choice seems to be correct, and there is still too much boost, then try a preset with
less boost, such as the Acoustic (Flat) preset and make sure the Tone controls have not been set all the way up.
Finally, realize that even though the SP®2P is a powerful and high output unit, it does ultimately have limits, and
it may need additional powered units (or a subwoofer) to provide enough sound output or coverage. In this case,
try turning the mixer levels down a little to see if that clears things up. If, after checking all the things listed to
check and anything else you can think of to check safely, and the system still exhibits problems, carefully note all
conditions and check with your Peavey dealer for advice.
Care and Maintenance
Your SP®2P is a sturdy and durable product and will provide years of reliable use if properly cared for. Use com-
mon sense and read the safety warnings to avoid hazardous operating conditions.
The unit must be disconnected from the AC power source before any work is done on it. Refer all servicing to
qualified service personnel.
Sunlight/Heat
Avoid prolonged exposure to direct sunlight, as this may cause the unit to overheat and thermally shut off.
Excessively hot operating conditions can also cause a thermal shutdown.
Do not store in extremely hot or cold conditions or extremely high humidity. Always allow unit to come to room
temperature before use.
Cleaning
Never clean the SP®2P while plugged in or turned ON! When the unit has been fully disconnected from AC
power sources, use a dry cloth to remove soil or other dirt. Never use strong solvents on the SP®2P, as they could
damage the cabinet. Do not allow ANY fluids to drip inside the SP®2P.
Touch-Up
To touch up the painted surfaces of the SP®2P, you can use Peavey® Black Touch-Up paint (part # 00052110).
Never paint the enclosure or other parts while the unit is plugged in or turned on!
Advertisement
