Advertisement
Electronic Crossover: DSP based, with LCD display and Rotary Encoder Knob for selection of EQ presets and
Graphic EQ. Crossover Frequency Set to 2.0 kHz. Low Pass slope: 24 dB/octave, High Pass slope: 24 dB/octave
DSP Section Specifications:
Latency: Approx. 2.7 msec
Sampling frequency: 96 kHz
Bit Depth: 24 bits for ADC/DAC, 32 bits for DSP calculations.
Enclosure materials and finish:
Plywood with a textured black polyurethane finish. Full length black powder coated metal grille.
Mounting:
12) M8 Threaded Mounting Suspension Points (3 top, 3 bottom and 2 each side & 1 each top rear and bottom
rear). Built-in stand-mount adapter and four large rubber feet on bottom for floor use
Dimensions:
H x W x D
26.53 in. x 16.75 in. x 16.93 in.
674 mm x 426 mm x 430 mm
Weight:
59 lbs. (26.8 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Electronic input impedance (nominal):
Balanced inputs: 10 k ohms line level sensitivity selected.
Unbalanced input: 5 k ohms, line level sensitivity selected.
Mic switch sensitivity Increase: 26 dB
Infrasonic filter protection: 36 dB/octave roll-off
Nominal amplifier frequency response: +0, -1 dB from 10 Hz to 30 kHz
Hum and noise: Greater than 90 dB below rated power
DDT dynamic range: Greater than 14 dB
THD and IM: Typically less than 0.1 %
Damping factor: Greater than 50 @ 1000 Hz, 4 ohms
Power requirements of Peavey® SP®2P system (domestic):
Nominal 200 watts, 120 VAC, 60 Hz
Fuse Type
For 120 VAC USE: International fuse classification T10AH 250V. In the USA, types GDC, GMC, 215, 218, and
477 cartridge-style 5 x 20 mm size time-delay fuses with a 10 amp 250V rating can be used.
Advertisement
