Setting Water Flow Rate - Cornelius FlavorFusion Series Installation Manual

Setting Water Flow Rate

Setting the water flow rate will require a timed dispense. To accomplish this, the following procedure
should be followed:
1. Enter programming mode for the valve
block by simultaneously pressing and
holding both programming buttons for 4
seconds. The LED's for flavors 1-4 should
flash off and then back on. The drink icon
should turn off.
2. Set the valve block to a 4 second pour
mode by simultaneously pressing and
holding Flavor 1 and Flavor 4 buttons until
the flash pattern for all four buttons
changes.
3. Place an empty ratio cup under the
appropriate nozzle and press the left
program button for a 4 second dispense of
carbonated water. There should be
approximately 10 oz. dispensed.
4. If necessary, adjust the water flow control,
empty ratio cup, and repeat step 3.
Otherwise empty ratio cup and repeat step
3 using the right program button for plain
water.
5. Exit 4 second pour mode by simultaneously pressing and holding Flavor 1 and Flavor 4 buttons until
the flash pattern for all for buttons changes.
6. Exit programming mode by simultaneously pressing and holding both programming buttons for 4
seconds.
Bonus Flavor
Programming Buttons
and Right)
Optional
Bonus Flavor Icon
Optional
Bonus Flavor Button 1
Optional
Bonus Flavor Button 2
Optional
Bonus Flavor Button 3
Optional
Bonus Flavor Button 4
Optional
Bonus Flavor Nozzle
Optional
© 2005-2010, IMI Cornelius Inc.
(Left
Figure 3. Valve with Flow Adjusters
(see plumbing diagram for plumbing and valve configura-
Figure 4
- 8 -
FlavorFusion Installation Manual
Flow Adjuster Detail
(Water)
tion)
Brand Flavor
Programming
Buttons 
(Left and 
Right)
Drink Icon
Brand Flavor Button 1
Brand Flavor Button 2
Brand Flavor Button 3
Brand Flavor Button 4
Brand Flavor Nozzle
Publication Number: 621057601INS