Toshiba RAV-GM802ATW-E Installation Manual page 8

Table of Contents

Advertisement

• Upon completion of the installation work, check for refrigerant leaks
and check the insulation resistance and water drainage. Then
conduct a test run to check that the air conditioner is operating
properly.
• After the installation work, confirm that refrigerant gas does not leak.
If refrigerant gas leaks into the room and flows near a fire source,
such as a cooking range, noxious gas may be generated.
Explanations given to user
• Upon completion of the installation work, tell the user where the circuit
breaker is located. If the user does not know where the circuit breaker
is, he or she will not be able to turn it off in the event that trouble has
occurred in the air conditioner.
• If you have discovered that the fan guard is damaged, do not
approach the outdoor unit but set the circuit breaker to the OFF
position, and contact a Qualified service person*(1) to have the
repairs done. Do not set the circuit breaker to the ON position until the
repairs are completed.
• After the installation work, follow the Owner's Manual to explain to the
customer how to use and maintain the unit.
Relocation
• Only a Qualified installer *(1) or Qualified service person *(1) is
allowed to relocate the air conditioner. It is dangerous for the air
conditioner to be relocated by an unqualified individual since a fire,
electric shocks, injury, water leakage, noise and/or vibration may
result.
• When carrying out the reclaim work shut down the compressor before
disconnecting the refrigerant pipe. Disconnecting the refrigerant pipe
with the service valve left open and the compressor still operating will
cause air, etc. to be sucked in, raising the pressure inside the
refrigeration cycle to an abnormally high level, and possibly resulting
in injury, etc.
13-EN
– 7 –
• When relocating the model GM110, GM140, GM160 unit, use the
cable ties specified under "How to wire" in Section 7 "Electrical work"
or equivalent means to fix the wires to the valve fixing plate.
(*1) Refer to the "Definition of Qualified Installer or Qualified Service Parson"
14-EN

Advertisement

Table of Contents
loading

Table of Contents