Termination Clearances - Empire Comfort Systems DVCP32BP30N-4 Installation Instructions Manual

Termination clearance for buildings with combustible and noncombustible exteriors.
INSIDE CORNER
"A" = COMBUSTIBLE 9-in (229mm)
= NONCOMBUSTIBLE 2-in (51mm)
BALCONY
WITH PERPENDICULAR SIDE WALL
"G" = COMBUSTIBLE 9-in (229mm)
= NONCOMBUSTIBLE 2-in (51mm)
"H" = COMBUSTIBLE 18-in (457mm)
= NONCOMBUSTIBLE 12-in (305mm)
Vertical Sidewall Installations
Important! Minimum clearance between vent pipes and
combustible materials is 3 inches (76 millimeter) on top, and 2
inches (25 millimeter) on bottom and sides.
Important! When vent termination exits through foundation less
than 20 inches (508 millimeter) below siding outcrop, the vent
pipe must extend outward so that the horizontal vent termination
is located flush to, or beyond the outcrop siding.
Information on Various Venting Routes and Components
Important: Locate the fireplace in such a way that minimizes the
number of offsets and horizontal vent length.
Venting system must maintain a balance between the
combustion air intake and the flue gas exhaust. Limitations to
vent configurations apply.
39612-4-0620

TERMINATION CLEARANCES

OUTSIDE CORNER
"F" = COMBUSTIBLE 6-in (152mm)
= NONCOMBUSTIBLE 6-in (152mm)
BALCONY
WITH NO SIDE WALL
Figure 21
RECESSED LOCATION
"C" = CLEARANCE FROM CORNER
IN RECESSED LOCATION
COMBUSTIBLE 9-in (229mm)
NONCOMBUSTIBLE 2-in (51mm)
"D" = MINIMUM WIDTH FOR BACK WALL
OF A RECESSED LOCATION
COMBUSTIBLE 38-in (965mm)
NONCOMBUSTIBLE 24-in (610mm)
"E" = MAXIMUM DEPTH OF 48-in (1219mm)
FOR RECESSED LOCATION
ATTENTION: Vinyl Soffit, Vinyl Ceiling, Vinyl Overhang
Disclaimer
Clearances are to heat resistant material (i.e. wood, metal). This
does not include vinyl. Empire Comfort Systems Inc. will not be held
responsible for heat damage caused from terminating under vinyl
overhangs, vinyl ceilings or vinyl ventilated/unventilated soffits.
Page 15