Single-Graphics Card; Removing The Single-Graphics Card - Dell Alienware Aurora R16 Owner's Manual

Steps
1. Ensure that the securing clips are extended away from the memory-module slot.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Insert the memory module into the memory-module slot and press the memory module down until it snaps into position and the
securing clips lock in place.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
NOTE: Repeat step 1 to step 3 to replace any other memory modules installed in your computer.
Table 16. Memory configuration matrix
Configuration
16 GB DDR5
32 GB DDR5
64 GB DDR5
Next steps
1. Install the left-side cover.
2. Follow the procedure in

Single-graphics card

Removing the single-graphics card

Prerequisites
1. Follow the procedure in
2. Remove the left-side cover.
After working inside your
Before working inside your
DIMM1
8 GB
16 GB
32 GB
computer.
computer.
Slot
DIMM2
8 GB
16 GB
32 GB
53