Table of Contents
Advertisement
USB Connection
IMPORTANT !
You may want to back up your files before making
any connections to the box in order to avoid any
possible data loss. Note that manufacturer will not be
responsible for any file damage or data loss.
You can connect a USB hard disk drive or USB
memory stick to your box by using the USB input(s) on
your box. This feature allows you to play files stored
in a USB device or record programmes.
2.5" and 3.5" inch (hdd with external power supply)
external hard disk drives and USB memory sticks are
supported
for USB Recording and media browser
functions.
To record a programme, you should first connect a
USB disk drive to your box. Otherwise, recording
feature will not be available.
It is possible that certain types of USB devices (e.g.
MP3 Players) or USB hard disk drives/memory sticks
may not be compatible with this device.
The device may not support all disk formats. If you
connect a USB device with an unsupported format,
then you will be asked to format the content. See the
USB Recording section in the following pages for
more information on disk formatting. Note that ALL the
data stored on the USB device will be lost and then the
disk format will be converted to FAT32 in such a case.
USB Storage Device Connection
Plug your USB device into the USB input on the box.
Plug or unplug your USB device while the box is
switched off.
If you are going to connect a USB hard disk drive to
the box, USB connection cable used between the disk
drive and the box should have a USB logo and should
be as short as possible.
While formatting a USB hard disk drive that has
1TB (Tera Byte) or more storage capacity, you can
experience problems with the formatting process.
In such a case, you should format the disk with your
personal computer. If you format the disk on a PC,
the only supported format is FAT32 for recording
functions. NTFS formatted drives are supported for
read only.
CAUTION !
Quickly plugging and unplugging USB devices, is a
very hazardous operation. Wait a little while before
each plugging and unplugging as the player may still
be reading files. Failure to do so may cause physical
damage to the USB player and especially the USB
device itself.
Do not pull out the USB device while playing or
recording a file.
Power Connection
IMPORTANT:
operate on 12V DC. For this, an adaptor is used which
gives 12 V voltage. Connect this adaptor to a system
that supplies 220-240 V AC, 50/60Hz.
After unpacking, allow the set-top box to reach the
ambient room temperature before you connect the
set to the mains.
Note: If a car cigarette lighter socket power plug adaptor is
going to be used, it should be noted that if the output voltage
reduces to lower than 12V, a smartcard error can be caused.
AC Adaptor
Power On-Off
Be sure that you put through all the cable connections.
After plugging in the power adaptor cord of the set-
top-box to the main supply, a LED on the front panel
will illuminate in red and then stay in green (Power
on mode).
Auto Power Down
The Auto Power Down option in the Settings >
System > More menu is set to 4 Hours by default.
If the box has been left on and not been operated
during the set time, it will switch into standby mode
after the set time has expired. A message will be dis-
played two minutes before going into standby mode.
You can disable this option by setting as Off or set
between 1 to 8 hours.
English - 6 -
This set top box is designed to
to POWER INPUT
DC 12V Term nal
Advertisement
Table of Contents
