Table of Contents
Advertisement
Figure 44
4. Install the battery in the machine and connect
the battery cables; refer to Installing the
Battery.
Note: Do not run the machine with the
battery disconnected, electrical damage may
occur.
Servicing the Fuses
The electrical system is protected by fuses. It
requires no maintenance, however, if a fuse blows
check component/circuit for malfunction or short.
The fuses are as follows:
• Main F1-30 amp, blade-type
• Alternator F2-25 amp, blade-type
1. Unlatch the seat and raise the seat to gain
access to fuse holder (Figure 45).
Figure 45
1. Main F1-30 amp
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse (Figure 45).
2. Alternator F2-25 amp
Drive System
Maintenance
Adjusting the Tracking
Note: Determine the left and right sides of the
machine from the normal operating position.
The right hand pump has a knob for adjusting the
tracking.
Important: Adjust the handle neutral and
hydraulic pump neutral before adjusting
the tracking. Refer to Adjusting the Handle
Neutral and Adjusting the Hydraulic Pump
Neutral.
1. Push both control levers forward the same
distance.
2. Check if the machine pulls to one side. If it
does, stop the machine and set the parking
brake.
3. Unlatch the seat and tip the seat up to access
the tracking knob.
4. Adjust the tracking as follows (Figure 46):
• To make the machine go right, turn the
knob towards the right side of the machine.
• To make the machine go left, turn the knob
towards the left side of the machine.
39
Advertisement
Table of Contents
