Sanitizing And Water System Cleaning - Scotsman SCE170 User Manual

SCE170

Sanitizing and Water System Cleaning

Cleaning Water System:
The water system is cleaned by pumping a mixture
of water and nickel safe type ice machine
cleaner through the water distributor, over the
evaporator and back to the reservoir.
1. Open the door and empty the bin of ice.
2. Remove the right front grill.
3. Locate the Harvest switch; activate harvest
cycle for 2 minutes or until ice falls from the
evaporator.
4. Locate and move the ON/OFF/CLEAN switch to
CLEAN.
5. Open and close the curtain to release any
cubes.
6. Mix a solution of 1 quart of warm (95
water and 1 ounce of nickel safe ice machine
cleaner, such as Scotsman Nickel-Safe.*
Ice Machine Cleaner
contains acids. These
compounds may cause
burns.
If swallowed, DO NOT
induce vomiting. Give
large amounts of water or
milk. Call Physician
immediately. In case of
external contact, flush
with water.
KEEP OUT OF THE
REACH OF CHILDREN.
7. Locate the purge switch, push it to ON and hold
it ON until the reservoir is nearly empty.
Harvest
Switch
Purge
Switch
On/Off/Clean
Switch
8. Immediately pour the cleaning solution into the
reservoir and allow it to circulate through the water
system for 20 minutes.
Pouring In
Cleaning Solution
0 0
F. - 115 F.)
9. Either A) Move the purge switch ON and hold it
until the reservoir is nearly empty; or
B) Remove the drain plug, drain the reservoir &
replace the plug.
10. Open the curtain and check the condition of
the evaporator surface, if it appears clean procede
to the next step. If mineral scale is still present,
repeat steps 6-9 one more time.
Note: The ice making portion of the water system
should be sanitized after cleaning by repeating
steps 7-9, except substitute an approved sanitizing
solution (such as a mixture of 1 oz. of household
bleach to 2 gallons of warm {95
for the cleaning solution.
Note: Sanitizer need only circulate water system
for 2 minutes, or the time on the sanitizer
instructions. Retain the balance of the sanitizer
solution for sanitizing the bin interior.
11. After the reservoir refills, move the purge
switch up until the reservoir is nearly empty. Allow
the reservoir to refill. Repeat 4 times.
12. Move the ON/OFF/CLEAN switch to ON and
replace the grill.
13. Discard the next batch of cubes.
14. The unit is now ready for automatic operation
or sanitizing of the ice storage bin.
* Scotsman Nickel Safe Cleaner is available by
ordering part number 19-0636-06 (8 oz bottle).
October 1998
Page 14
Reservoir
Curtain
0 0
F. - 115 F.} water)