Water Distributor - Scotsman SCE170 User Manual

Scotsman sce170 ice machine: user guide
Table of Contents

Advertisement

SCE170

Water Distributor

Inner Distributor
Wing Nut
The water distributor tube will typically not require
Tube Water Outlet
any service beyond removal for cleaning. If
Evaporator Stud
needed, remove the water distributor by:
Outer Distributor
1. Remove the hood.
Tube
2. Remove lower right front grill.
3. Switch master switch to OFF.
4. Loosen hose clamp at water distributor inlet (on
left).
5. Remove the two wing nuts holding the
distributor to the evaporator.
6. Lift water distributor off the studs.
7. Pull the inner distributor tube out of the outer
distributor tube and clean out all holes.
Water Oulet
To reassemble.
8. Align the tube so that the inner distributor tube's
holes are opposite the outer distributor tube's
holes.
Evaporator
9. Place the end caps onto the water distributors.
Side View of the Water
Bracket
Distributor
10. Place the distributor tube onto the mounting
studs:
NOTE: The Outlet Holes Face Down, Towards
The Evaporator.
11. Replace the wing nuts, hose and hose clamp.
12. Switch the machine back on and check the
water flow.
13. Replace the hood.
Wing
Inner Water
Nut
Distributor Tube
End Cap
Hose Clamp
Water Inlet
Outer Distributor
Hose
Tube
Evaporator Bracket
Water Distributor Assembly
October 1998
Page 28

Advertisement

Table of Contents
loading

Table of Contents