For The Installer; Location - Scotsman FM1500 Manual

FM1500

FOR THE INSTALLER

Location

After uncrating and inspection, the
unit is ready for installation. It is
important that the machine be
installed in a location where it has
enough space around it to be
accessible for service, and minimum
of 6" be allowed to the left, right and
top for air circulation on air cooled
models. Try to avoid hot, dirty and
crowded locations. Be sure that the
location for the machine is within the
limitations described on page 3.
Storage Bin
Tip the storage bin on its back, using
parts of the carton to protect the
exterior finish. Install the legs into
the threaded holes in the bottom of
the bin. Turn the leg levelers all the
way in preparation for leveling later.
Return the bin to the upright
position, remove paper covering the
bin gasket.
Install bin top if required.
Note: Do not push bin into position,
but lift it there. Pushing a bin,
especially one with ice in it, can
cause damage to the legs and the
leg mounts.
Ice Maker
The machine is heavy, so the use of
a mechanical lift is recommended for
lifting the machine high enough to
install on top of the bin. After the unit
is placed on the bin, line it up so it is
even with the back, left, and right
sides. Secure the machine to the bin
with the hardware provided with the
machine.
FASTEN THE MACHINE
TO THE BIN WITH THE
HARDWARE SUPPLIED
WITH THE ICE MAKER
February, 1989
Page 4
LEVEL THE
ASSEMBLY
GASKET