Scotsman CMS1002W Manual page 16

CMS1002W
CLEANING
SANITIZE WATER SYSTEM
1. Remove and discard all ice from the bin.
2. Remove front panel.
3. Drain the reservoir
4. Prepare 2 gallons of an approved sanitizer
solution in accordance with the instructions on the
package, or use the following instructions for use
of household bleach, if it meets local codes:
Mix a sanitizing solution of 1 ounce of household
bleach to 2 gallons of water.
5. Pour 1 gallon of the sanitizer into the ice maker
reservoir.
6. Move the Wash/Off/Switch switch to "Wash",
and allow the solution to circulate for a MINIMUM
of 5 minutes.
7. Move the Wash/Off/Switch switch to "Off".
8. Remove the drain plug and drain the reservoir.
9. Using a clean sponge and the remainder of the
sanitizer solution, wipe the interior of the
evaporator cover and the inside of the storage bin,
taking care to wipe all surfaces that are normally in
contact with ice.
10. Replace the evaporator cover. Replace the
front panel.
11. Move the master switch to ON.
SANITIZE ICE STORAGE BIN
This procedure is to be done monthly
1. Remove and discard all ice from the bin.
2. Switch the ice maker off.
2. Prepare 2 gallons of an approved sanitizer
solution in accordance with the instructions on the
package, or use the following instructions for use
of household bleach, if it meets local codes: Mix a
sanitizing solution of 1 ounce of household bleach
to 2 gallons of water.
3. Using clean rubber gloves and a clean cloth,
wipe all interior surfaces of the ice machine and
ice storage bin with the sanitizing solution.
Immerse any small parts in the sanitizing solution
and wash the parts, flushing the solution
thoroughly in, over and through all parts and
surfaces of the parts being cleaned.
ON/OFF/WASH
SWITCH
September, 1993
Page 16
4. Allow to air dry.
5. Switch the ice
machine back on.
RESERVOIR
DRAIN