Table of Contents
Advertisement
1.9.1 Hart
Operation
Mode
1.9.2 Hart PV
1.10 Volume
Config
Page 22
This setting is used to set HART Polling Address for multiple
HART instruments in the HART loop. Press
setting mode. Use
default address is 00 and the maximum address reaches 63.
After editing, press
abandon programming.
This setting is used to set HART PV value. There are 3 options
for this value: Distance/Height/Volume. When the menu
number is 1.9.2, press
Press
confirm.
This setting is used to set parameters for Volume calculation.
Press
settings and Display in LCD is as follows
Current Output
SLN 700 SmartLine NCR Level Transmitter User's Manual
or
to confirm, and press
key. Display in LCD is as follows.
key to select the required item and press
to enter the Volume configuration menu for detail
to enter the
keys to set parameters. The
to
Revision 2
to
Advertisement
Table of Contents
