Functional Description - Makita 9741 Instruction Manual

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting front roller
1
D
► 1. Wing nut 2. Front roller
The front roller allows you to apply uniform pressure to
the workpiece. To adjust the front roller, set the tool on
a flat surface and loosen the wing nut. Adjust the front
roller up or down until the clearance distance (D) is
about 2 mm (5/64"). Tighten the wing nut securely.
Switch action
1
► 1. Switch trigger 2. Lock button
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
2
2
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing wheel
1
► 1. Spindle 2. Wheel 3. Output shaft 4. Hex wrench
To remove the wheel, insert one hex wrench into the
end of the spindle and another hex wrench into the end
of the output shaft. Turn the hex wrench in the output
shaft clockwise while securely holding the hex wrench
in the spindle so that the wheel cannot revolve. Pull the
output shaft out from the wheel. Move the wheel slightly
away from the spindle and remove the wheel from the
tool.
NOTE:
• The output shaft has a left hand thread.
To install the wheel, follow the removal procedures in
reverse. When installing it, be sure to align the notches
in the wheel with the pins on the spindle.
3
4
► 1. Notch 2. Wheel 3. Spindle 4. Pin
4 ENGLISH
2
4
1
3
2