Table of Contents
Advertisement
Close the service flap.
6.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into manual dosing compartment
and start the [ Drain programme.
The drain hose at the siphon
is blocked
Turn the programme selector to Off.
1.
Pull out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Cleaning and maintenance
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
Turn off the water tap.
1.
Select the i Cottons (activate
2.
G SpeedPerfect setting)
programme.
If your appliance with
Note:
intelligent dosing system
need to deactivate the intelligent
dosing system.
Select the Start/Reload A button.
3.
Allow the programme to run for
approx. 40 seconds.
Turn the programme selector to Off.
4.
Pull out the mains plug.
5.
Clean the filters:
Disconnect the hose from the rear of
1.
the appliance.
Use pliers to remove the filter.
2.
*
Depending on the module
en
*
, you also
43
Advertisement
Table of Contents
