Table of Contents
Advertisement
Press and hold Ž i-DOS for approx.
5.
three seconds, briefly press any
other selectable button or wait
approx. 10 seconds to exit setting
mode.
Notes
The changes are applied to all
■
programmes in which dosing is
possible.
The changes are saved until the next
■
time they are changed and are
retained even after the appliance has
been switched off.
Filling the dispensers
Notes
See the instructions in chapter
■
~ "Before setting up Ž i-DOS"
on page 35
If w or © flashes, fill the relevant
■
dispenser. ~ Page 35
Fill the dispensers as follows:
Pull out the detergent drawer.
1.
Open the dispenser lids.
2.
Intelligent dosing system
Pour liquid detergent and fabric
3.
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the max. marking.
– See the instructions in chapter
~ "Ž i-DOS Setting the dosage"
on page 36
Close the dispenser lids.
4.
To prevent the detergent
Note:
drying out or drying up, do not leave
the dispenser lids open for a long
period of time.
Push in the detergent drawer.
5.
When refilling the dispensers,
Note:
always use the same type of liquid
detergent or fabric softener.
Do not mix different types of liquid
detergent or fabric softener, as this can
form lumps that may block the Ž i-DOS
pump unit.
If you switch to a different liquid
detergent or fabric softener (type,
manufacturer, etc.), empty the relevant
dispenser completely and clean it
beforehand. ~ Page 38
en
37
Advertisement
Table of Contents
