Rails - Bosch 500 Series Use And Care Manual

Before running the cleaning function
Remove racks, rails, accessories and ovenware from the
cooking compartment.
Cleaning the cooking compartment floor and the inside
of the appliance door
Remove the worst dirt from the cooking compartment
floor, the inside of the appliance door and the interior
lighting. Otherwise, patches will appear that cannot be
removed.
CAUTION
9
Do not use oven cleaner on the self-cleaning
surfaces. These will damage the surfaces. If oven
cleaner does get onto these surfaces, dab it off
immediately using water and a sponge cloth. Do not
rub the surface and do not use abrasive cleaning
aids.
WARNING
9
RISK OF BURNS
;
The appliance will become very hot on the
outside during the cleaning function. Never touch
the appliance door. Allow the appliance to cool
down. Keep children away from the appliance.
Setting the cleaning function
Before setting the cleaning function, ensure that you
have followed all instructions for preparation.
The duration of the cleaning function is preset to 1 hour.
It cannot be changed.
1. Touch the menu field.
The list of operating modes is displayed.
2. Touch the "EcoClean" text field.
3. Press the Start/Stop button
The cooking time will count down on the display. The
heating line does not appear for the cleaning function.
The cleaning function starts.
Ventilate the kitchen when the cleaning function is
running.
When the cleaning function has ended, an audible signal
sounds. The cooking time 00 m 00 s is shown in the
ÿ
display. Press the On/Off button to switch off the
appliance.
Setting a later end time
You can set a later end time. Before starting the
appliance, touch the "End" text field and set a later end
time using the rotary selector.
The appliance switches to standby after it is started. The
end time can no longer be changed.
Cancelling
If you would like to cancel the cleaning function, switch
the appliance off using the
longer pause the operation using the
button.
l
to start.
ÿ
On/Off button. You can no
l
Start/Stop
Note: The operating hour counter is not reset. The
instruction for the cleaning function is still shown on the
display.
Once the cleaning function has ended
Once the cooking compartment has cooled down, wipe
down the cooking compartment with a damp cloth if
necessary.
Note: During operation and while the cleaning function
is active, reddish patches may form on the surfaces. This
is not rust, but food residues. These patches are not
hazardous to your health and do not limit the cleaning
capacity of the self-cleaning surfaces.

Rails

With good care and cleaning, your appliance will retain
its appearance and remain fully functioning for a long
time to come. This will tell you how to remove the shelves
and clean them.
Detaching and refitting the rails
WARNING
9
RISK OF BURNS
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep
children away from the appliance.
Detaching the rails
1. Lift the rail slightly at the front
!
(figure ).
2. Then pull the whole rail to the front and remove it
"
(figure ).
Clean the rails with cleaning agent and a sponge. For
stubborn dirt deposits, use a brush.
‚ ƒ
and detach it
25