Making The Amount Of Movement In The Screen Constant (Proportional); Displaying A Still Image While Switching The Surveillance Location (Freeze); Setting The Starting Point (0 Degrees) Angle Information (Set North) - Sanyo VCC-MC500 Instruction Manual

Pan and Tilt Settings (PAN/TILT)
Making the amount of movement in the
B
screen constant (PROPORTIONAL)
The proportional function allows you to make the amount of
movement in the screen constant by changing pan/tilt operation
speed during manual operation according to the zoom
magnification power.
1
Use the joystick lever (xy) to select
[PROPORTIONAL] and use the lever (vw) to select
"ON".
PAN/TILT SETTING
PRESET POSITION
PROPORTIONAL
FREEZE
SET NORTH
TILT LIMIT
PRESET
MENU
Available settings:
• OFF: Disables the proportional function.
• ON: Enables the proportional function.
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
Displaying a still image while switching
C
the surveillance location (FREEZE)
While the surveillance location moves by the Sequence mode or
manual preset (PRESET GO) operations, the freeze function
displays the still image immediately before the camera starts
moving. After movement of the surveillance location completes,
the still image is switched to the video image of the new
surveillance location.
1
Use the joystick lever (xy) to select [FREEZE] and
use the lever (vw) to select "ON".
PAN/TILT SETTING
PRESET POSITION
PROPORTIONAL
FREEZE
SET NORTH
TILT LIMIT
PRESET
MENU
Available settings:
• OFF: Disables the freeze function.
• ON: Enables the freeze function.
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
31
SET y
ON
OFF
OFF
OFF
OFF
BACK
SET y
ON
ON
OFF
OFF
OFF
BACK
Setting the starting point (0 degrees)
D
angle information (SET NORTH)
When you install the camera and the starting point (0 degrees)
angle information for the camera needs to be specified, set the
angle information using the following procedure. You can set
any direction as the starting point (0 degrees) indicating north
direction.
1
Use the joystick lever to orient the camera in the
direction you want to set as the starting point.
2
Use the joystick lever (xy) to select [SET NORTH],
use the lever (vw) to select "SET", and press the
[ENTER] button.
When "SET" in the [SET NORTH] menu item changes to "ON",
the starting point (0 degrees) setting completes.
PAN/TILT SETTING
PRESET POSITION
PROPORTIONAL
FREEZE
SET NORTH
TILT LIMIT
PRESET
MENU
Available settings:
• OFF: Does not set the starting point angle information.
• ON: Sets the starting point angle information.
• SET: Setting operation is in progress. Determine the
camera's orientation, then press the [ENTER] button.
This completes the setting and "SET" changes to
"ON".
☞
After completing setting, use the lever to move the cursor to
[MENU] and select "BACK" or "END".
• The camera rotates clockwise. North is regarded as 0
degrees. For example, 90 degrees represent east.
• To display the camera's angle information, set
[DIRECTION] in the DISPLAY screen under the
INFORMATION screen to "ON".
SET y
ON
OFF
ON
OFF
OFF
BACK