NordicTrack NTEX14921-INT.0 User Manual page 29

HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. To adjust the drive belt,
first unplug the power adapter.
See EXPLODED DRAWING B on page 35. Using
an adjustable wrench, turn the Right Pedal (21) coun-
terclockwise and remove it.
See EXPLODED DRAWING A on page 34. Using
a standard screwdriver, gently release the tabs on the
Front Shield (58) and the Top Shield (44). Remove the
Front Shield and the Top Shield.
Next, identify the Left and Right Front Shields (13, 14).
Remove all of the Screws (77, 85) from the Left and
Right Front Shields; make sure to note the location
of each size of Screw.
47
Then, use a standard screwdriver to gently release the
tabs on the right Shield Disc (52). Rotate the Shield
Disc and remove it. Then, gently remove the Right
Front Shield (14).
84
Next, loosen the M6 x 20mm Hex Screw (84). Then,
tighten the M10 x 50mm Hex Screw (83) until the Drive
83
Belt (47) is tight. When the Drive Belt is tight, tighten
the M6 x 20mm Hex Screw.
When the drive belt is correctly adjusted, reattach
the parts that you removed. Then, plug in the power
adapter.
29