Checking The Battery Charge Level; Changing Tools; 2-Speed Gearbox; Removing The Chuck - Parkside PBSA 12 F5 Translation Of The Original Instructions

Checking the battery charge level

When the appliance is switched on, the remaining
charge will be shown on the battery LED
follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the quick-release chuck
by turning it . After you have attached the
desired tool and tightened it by turning the chuck
you can continue working. The spindle lock is
automatically released when the motor starts
(ON/OFF switch pressed).

2-speed gearbox

CAUTION!
► Operate the speed selector
the appliance is at a standstill. Otherwise the
appliance can be damaged.
In first gear
(speed selector in position 1)
you can reach a speed of approx. 350 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear
(speed selector in position 2)
you can reach a speed of approx. 1300 rpm for
carrying out drilling work.

Removing the chuck

If you want to use the bit adapter
remove the quick-release chuck
Removing the chuck
♦ Hold the quick-release chuck
front.
♦ Pull/push the chuck ring
the quick-release chuck
The quick-release chuck
can be removed towards the front.
PBSA 12 F5
as
can be opened
only when
, you must
.
firmly from the
in the direction of
10a
.
is now unlocked and
Attaching the quick-release chuck
♦ To replace the quick-release chuck
the chuck ring
chuck . Push the quick-release chuck
the bit adapter
to click the quick-release chuck
NOTE
► If the quick-release chuck
automatically click into place, turn the chuck
ring .
10a

Using the bit adapter

After removing the quick release chuck
use the bit adapter
,
♦ Insert a suitable bit into the bit adapter
♦ Push the bit into the bit adapter
stop.
The guidance and the magnetic holder keep the
bit firmly in place.
♦ Pull the bit out of the bit adapter

Torque selection ring/drill setting

You can set the torque using the torque selection
ring .
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position .
♦ Push the speed selector
work (position: 2).
towards the quick-release
10a
. Let go of the chuck ring
into place.
does not
.
as far as the
.
forward for drilling
GB │ IE
, pull
over
10a
, you can
.
to the
│ 7