Makita MAC5200 Owner's Manual page 34

Nose adapter
CAUTION :
Always lock the trigger and disconnect the hose before installing or removing the nose adapter.
When nailing workpieces with easily-marred surfaces, use
the nose adapter. It is factory installed at the rear of the tool.
Attach the nose adapter to the contact arm (see right). When
not in use, store the nose adapter at the rear of the tool to
keep it from being lost.
Nose piece storing portion
Contact arm
\
Nose adapter
a - t
I
Loading nailer
CAUTION:
Always lock the trigger and disconnect the hose before loading the nailer.
Select nails suitable for your work. Depress the latch lever
and open the door and magazine cap.
Lift and turn the coil support plate to set it to the correct
step. When loading 57 or 65 mm (2-1/4", 2-1/2") long nails,
use the bottom step. When loading 45 or 50 mm (1-3/4",
2") long nails, use the middle step. When loading 32 or
38 mm (1-1/4", 1-1/2") long nails, use the top step. If the tool
is operated with the coil support plate set to the wrong step,
poor nail feed or malfunction of the tool may result.
I
Coil support plate
12