Makita MAC700 Owner's Manual
  1. Manuals
  2. Brands
  3. Makita Manuals
  4. Air Compressor
  5. MAC700
  6. Owner's manual

Makita MAC700 Owner's Manual

Oil lubricated air compressor
Hide thumbs Also See for MAC700:
Table of Contents

Advertisement

Quick Links

OWNERS MANUAL FOR
Oil Lubricated Air Compressor
Model #
Horsepower
SCFM @ 40 PSIG
SCFM @ 90 PSIG
Cut-In Pressure
Cut-Out Pressure
Bore
Stroke
Voltage -Single Phase
Motor RPM
Amperage @ max pressure
Tank Size
CSA/US Listed
Minimum Circuit Requirement: 15 AMPS
*A circuit breaker is preferred. Use only a fuse or circuit
breaker that is the same rating as the branch circuit the air
compressor is operated on. If the air compressor is connected
to a circuit protected by fuses, use time delay fuses.
IMPORTANT — Read the Safety Guidelines and ALL
instructions carefully before operating.
www.makitatools.com
MODEL No
MAC700

SPECIFICATION CHART

MAC700
2
3.8
3.3
100 PSI
130 PSI
47 mm
44 mm
120
1720
12.4
2.6 Gallon
Yes

Advertisement

Table of Contents
loading

Related Manuals for Makita MAC700

Summary of Contents for Makita MAC700

  • Page 1: Specification Chart

    *A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air compressor is operated on. If the air compressor is connected to a circuit protected by fuses, use time delay fuses.

  • Page 2: Table Of Contents

    INSTALLATION and BREAK-IN PROCEDURES ....9 Location Of the Air Compressor ......9 Lubrication and Oil .

  • Page 3: Warning Chart

    INJURY AND PROPERTY DAMAGE. READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. HAZARD WHAT CAN HAPPEN Unsafe operation of your air compressor Risk of could lead to serious Unsafe injury to you or others. Operation WARNING HOW TO PREVENT IT •...
  • Page 4 HAZARD WHAT CAN HAPPEN The following conditions could lead to Risk of Air a weakening of the Tank tank, and RESULT IN A Bursting VIOLENT TANK EXPLOSION RESULTING IN SERIOUS INJURY TO YOU OR OTHERS: • Failure to properly drain condensed water from the tank, causing rust and thinning of the tank...

  • Page 5: Safety Instructions

    HAZARD WHAT CAN HAPPEN • Your air compressor is powered by Risk of electricity. Like any Electric other electrically Shock powered device, if it is not used properly, it may cause electrical shock. • Electrical grounding: failure to provide adequate grounding...
  • Page 6 HAZARD WHAT CAN HAPPEN solvents, paint remover, insecticides, weed killers, Risk to etc., contain harmful Breathing vapors and poisons. (continued) • Breathing compressor or sprayed materials vapor can result in serious injury. The compressed air stream can cause soft Risk from tissue damage, and can Compressed propel dirt, chips, loose...

  • Page 7: Glossary

    The pressure at which the motor shuts off is called "cut-out pressure". DUTY CYCLE All Makita manufactured air compressors are recommended to be operated on not more than a 50% duty cycle. This means an air compressor that pumps air...

  • Page 8: Storage

    2. Protect the electrical cord and air hose from damage (such as being stepped on or run over). Store the air compressor in a clean and dry location. DESCRIPTION OF OPERATION DRAIN VALVE: The drain valve...

  • Page 9: Installation And Break-In Procedures

    INSTALLATION AND BREAK-IN PROCEDURES LOCATION OF THE AIR COMPRESSOR Locate the air compressor in a clean, dry and well-ventilated area. The air filter must be kept clear of obstructions, which could reduce air delivery of the air compressor. The air compressor...

  • Page 10: Initial Start Up Procedure

    CAUTION: Multi-Viscosity motor oils, like 10W 30, should not be used in an air compressor. They leave carbon deposits on critical components, thus reducing performance and compressor life. Use air compressor oil only.

  • Page 11: Operating Procedures

    AIR TANK RUPTURE. Note: If drain cock valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled. 10. After the water has been drained, close the drain valve. The air compressor can now be stored. Page...

  • Page 12: Maintenance

    ANY MAINTENANCE OR REPAIR, UNPLUG THE COMPRESSOR AND BLEED OFF ALL AIR PRESSURE. To ensure efficient operation and longer life of the air compressor unit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is...

  • Page 13: Service Instructions

    Allow oil to drain completely. 2.Replace the oil drain plug (The use of a sealing compound or Teflon tape to avoid leakage is recommended.) 3.Refill with the recommended oil to the proper level. SERVICE INSTRUCTIONS Air Filter - Inspection and Replacement: •...

  • Page 14: Troubleshooting Guide

    TROUBLESHOOTING GUIDE PERFORMING REPAIRS MAY EXPOSE VOLTAGE SOURCES, MOVING PARTS OR COMPRESSED AIR SOURCES. PERSONAL INJURY MAY OCCUR. PRIOR TO ATTEMPTING ANY REPAIRS, UNPLUG THE COMPRESSOR AND BLEED OFF TANK AIR PRESSURE. PROBLEM CAUSE Excessive Defective tank pressure pressure - switch.
  • Page 15 • Clean or replace air intake filter. Do not operate the air compressor in the paint spray area. • Plug unit into "live" electrical outlet. • Check and replace if required.
  • Page 16 PROBLEM CAUSE Motor will • Check valve is not run. stuck open. (con’t) • Loose electrical connections. • Possible defective capacitor. • Paint spray on internal motor parts. • Possible defective motor. • Fuse Blown, circuit breaker tripped. • Pressure unloader valve on pressure switch has not...

  • Page 17: Factory Service Centers

    Customer Record Date Purchased When you need service: Send complete tool (prepaid) Dealer’s Name and Address to one of the Makita Factory Service Centers listed, or to an Authorized Makita Service Center. Be sure to attach a Model No. letter to the outside of the carton detailing the problem Serial No.

  • Page 18: Warranty

    ONE YEAR from the date of original purchase. Should any trouble develop during this one year period, return the COMPLETE tool, freight prepaid, to one of Makita’s Factory or Authorized Service Centers. If inspection shows the trouble is caused by defective workmanship or material, Makita will repair, (or at our option, replace), without charge.
  • Page 19 3. How did you learn about this product: Other ( Magazine From Dealer Newspaper Store Display Catalog 4. Most favored points are: Design Features Size Price Makita Brand MODEL NO. YEAR SERIAL NO. PHONE 30-39 40-49 50-59 Radio Exhibition From Friend Previous Usage...
  • Page 20 First Class Postage Required Makita U.S.A., Inc. Post Office will not deliver without proper 14930 Northam Street postage La Mirada, CA 90638-5753...

Table of Contents