Toro 74657 Operator's Manual page 46

3. Measure from the tip of the blade to the flat
surface (Figure 53).
Figure 53
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between blade and the surface (A)
4. Rotate the same blade 180 degrees so that
the opposing cutting edge is now in the same
position (Figure 54).
Figure 54
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat
surface (Figure 55).
Note:
The variance should be no more than
3 mm (1/8 inch).
1. Opposite blade edge (in position for measuring)
g014973
2. Level surface
3. Second measured distance between blade and surface (B)
A. If the difference between A and B is greater
than 3 mm (1/8 inch), replace the blade with
a new blade; refer to
(page 47)
47).
Note:
new blade, and the dimension obtained
continues to exceed 3mm (1/8 inch), the
blade spindle could be bent. Contact an
Authorized Toro Dealer for service.
B. If the variance is within constraints, move to
the next blade.
Repeat this procedure on each blade.
g014974
46
Figure 55
Removing the Blades
and Installing the Blades (page
If a bent blade is replaced with a
g014973