Toro 74657 Operator's Manual page 29

7. Install the right mower blade; refer to
the Blades (page
8. Lift up the grass deflector and install 2 bolts
(5/16 x 3/4 inch) into the 2 holes along the deck
cutout.
9. Install the cutoff baffle to the mower deck
28).
Note:
Use the 2 locknuts (5/16 inch) to secure
the baffle to the mower deck.
Note:
The cutoff baffle was shipped with the
machine as a loose part.
1. Bolt (5/16 x 3/4 inch)
2. Cutoff baffle
10. Torque the fasteners to 7 to 9 N∙m (14 to 18
ft-lb).
11. Lower the grass deflector over the discharge
opening.
Important:
Ensure that the mower has
a hinged grass deflector that disperses
clippings to the side and down toward the
turf, while in side-discharge mode.
Installing the Right Baffle for
Mulching
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P position, shut off the engine, remove the
ARK
key, and wait for all moving parts to stop before
leaving the operating position.
3. Remove the cutoff baffle from the mower deck
(Figure 28).
4. Remove the right mower blade; refer to
Removing the Blades (page
5. Slide the right baffle under the mower deck and
secure it using 2 knobs and the curved washers
Installing
47).
Figure 28
3. Locknut (5/16 inch)
47).
(cupped side facing the mower) as shown in
Figure 26
Important:
right side of the right baffle is outside of the
mower and is flush with the mower wall.
(Figure
6. Install the right mower blade; refer to
the Blades (page
g015321
29
and Figure 27.
Ensure that the tab on the far
47).
Installing