Table of Contents
Advertisement
Pre-Maintenance
Procedures
Raising the Seat
Make sure that the motion-control levers are locked in
the P
position, and lift the seat forward.
ARK
The following components can be accessed by raising
the seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts
•
Fuel filter
•
Battery and battery cables
Releasing the Mower-Deck
Curtain
Loosen the 2 bottom bolts of the curtain to access the
top of the mower deck
Figure 32
1. Bottom bolt
Note:
Always tighten the bolts to connect the curtain
after maintenance.
(Figure
32).
2. Curtain
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all
Grease Type: No. 2 lithium grease
1.
Park the machine on a level surface, and
disengage the blade-control switch.
2.
Move the motion-control levers outward to the
P
position, shut off the engine, remove the
ARK
key, and wait for all moving parts to stop before
leaving the operating position.
3.
Clean the grease fittings
34) with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
1. Front caster tire
g027794
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4.
Connect a grease gun to each fitting and pump
grease into the fittings until grease begins to
34
lubrication points.
(Figure 33
Figure 33
Figure 34
3. Grease every 25 operating
hours
4. Engine
and
Figure
g014522
decal106-8717
Advertisement
Table of Contents
