Power Cord Replacement - Wolf MWD24 Technical Service And Parts Manual

Power Cord Replacement:

1) Drawer Microwave must be removed from its
installation. See Drawer Microwave Disassembly
(page 4-6).
DISCONNECT ELECTRICAL SUPPLY BEFORE
ATTEMPTING THIS PROCEDURE.
DANGEROUS HIGH VOLTAGE CAN BE PRESENT -
CAREFULLY READ AND FOLLOW ALL WARNINGS AT
THE BEGINNING OF THIS SECTION. (PAGE 4-2)
Wear gloves when handling sheet metal parts, sheet
metal edges may be sharp.
2) After unit has been made safe by unplugging cord
from supply receptacle and discharging High Voltage
Capacitor (See WARNINGS). Cord connectors can
be disconnected from noise fi lter unit. (Figure 4-11)
3) Only replace power cord with exact replacement cord
purchased from Wolf Appliance, Inc.
NOTE: PLEASE SEE "AFTER SERVICING" (Page 4-6)
WHEN REPAIR COMPLETE.
Upper Cabinet Component Replacement:
(Sensor, Stirrer Motor, Upper Thermal Limiter)
1) Drawer Microwave must be removed from its
installation. See Drawer Microwave Disassembly
(page 4-6).
DISCONNECT ELECTRICAL SUPPLY BEFORE
ATTEMPTING THIS PROCEDURE.
DANGEROUS HIGH VOLTAGE CAN BE PRESENT -
CAREFULLY READ AND FOLLOW ALL WARNINGS AT
THE BEGINNING OF THIS SECTION. (PAGE 4-2)
Wear gloves when handling sheet metal parts, sheet
metal edges may be sharp.
2) Wait 60 Sec. to discharge High Voltage Capacitor.
3) Using a phillips screw driver, remove screws (2 ea.
Component) that fasten component to top of unit.
(Figure 4-12)
NOTE: Stirrer motor shaft has fl at spots that must be
aligned with Stirrer Fan Assembly for reinstallation.
NOTE: PLEASE SEE "AFTER SERVICING" (Page 4-6)
WHEN REPAIR COMPLETE.
Drawer Microwave
4-9
Access & Removal
Figure 4-11 Power Cord Replacement
Figure 4-12 Upper Components
Black wire
White wire