Table of Contents
Advertisement
Theory of Operation
TOUCH CONTROL PANEL ASSEMBLY
OUTLINE OF TOUCH CONTROL PANEL
The touch control section consists of the following units.
1.
Key unit
2.
Control Unit
3.
Power unit
The principal functions of these units and the signals
communicated among them are explained below.
Key unit:
The key unit is composed of a matrix, signals generated
in the LSI are sent to the key unit from P3-100 - P3-107.
When a key pad is touched, a signal is completed
through the key unit and passed back to the LSI through
P20 - P23 to perform the function that was requested.
Control Unit and Power Unit:
Control unit consists of LSI, IC, reset circuit, indicator
circuit, power source circuit, relay circuit, buzzer circuit,
synchro-nizing signal circuit, keyboard unit circuit, humid-
ity sensor circuit and back light circuit.
1.
IC1 (LSI)
This is a microcomputer, responsible for controlling
the entire control unit.
2.
IC2
This is the IC to drive the Liquid Crystal Display.
3.
IC5
This is the IC to amplify the signal from the humidity
sensor.
4.
Reset Circuit
This circuit generates a signal which resets the LSI
(IC3-10) to the initial state when power is supplied.
5.
Indicator Circuit
A circuit to drive the Liquid Crystal Displays
(LCD3-10).
Drawer Microwave
6.
Power Source Circuit
This circuit generates voltages necessary in the
control unit from the AC line voltage. In addition, the
synchronizing signal is available in order to compose
a basic standard time in the clock circuit.
7.
Relay Circuit
A circuit to drive the magnetron, fan motor, stirrer mo-
tor and light the oven lamp.
8.
Buzzer Circuit
The buzzer is responsive to signals from the LSI to
emit audible sounds (key touch sound and comple-
tion sound).
9.
Synchronizing Signal Circuit
The power source synchronizing signal is available in
order to compose a basic standard time in the clock
circuit. It accompanies a very small error because it
works on commercial frequency.
10.
Door Sensing Switch (Microwave drawer)
A switch to "tell" the LSI if the drawer is open or
closed.
11.
Door Position Switch Front / Rear
The switch to "tell" the position of the Microwave
drawer door.
12.
Back Light Circuit
A circuit to drive the back light (Light emitting diodes
LD3-10- LD3).
13.
Humidity Sensor Circuit
This circuit detects moisture of the cooking food to
allow its automatic cooking.
14.
Microwave drawer door open-close Circuit
A circuit to drive the microwave drawer door open-
close motor.
3-10
Symbol
Voltage
Application
VC
+5V
LSI(IC3-10)
Advertisement
Table of Contents
