Table of Contents
Advertisement
Throttle only button ‑ Allows engine throttle advancement without shifting the engine. This is done by disengaging the shift
mechanism from the control handle. The throttle only button can be depressed only when the remote control handle is in the
neutral position.
Control handles ‑ Operation of the shift and throttle are controlled by the movement of the control handle. Push the control
handle forward from neutral with a quick firm motion to the first detent for forward gear and continue pushing forward to
increase speed. Pull the control handle back from neutral with a quick firm motion to the first detent for reverse gear and
continue pushing back to increase speed.
Control handle tension adjustment screw (not visible) ‑ This screw is used to adjust the effort required to move the remote
control handle. Refer to instructions provided with remote control for complete adjustment instructions.
Power trim switch ‑ See Power Trim section for detailed power trim operating procedures.
Trailer switch ‑ Used to raise drive unit for trailering, launching, beaching or shallow water operation. See Power Trim for
detailed trailer switch operation.
Zero Effort Features
a
Shift lever ‑ Shift functions are controlled by the movement of the shift lever. Shift into reverse by moving the shift lever to its
aft position. Shift into neutral by moving the shift lever to its center position. Shift into forward by moving the shift lever to its
forward position.
Throttle lever ‑ Throttle functions are controlled by the movement of the throttle lever. Increase the RPM by moving the throttle
lever forward. Achieve wide‑open throttle (WOT) by placing the throttle lever in its full forward position. Decrease RPM by
moving the throttle lever back. Achieve minimum RPM (idle) by placing the throttle lever in its full aft position.
Trim/tilt switch ‑ Refer to Power Trim.
Remote Controls (DTS Models)
Remote Controls
IMPORTANT: Your boat must be equipped with a Mercury Marine electronic remote control. Start in gear protection is provided
by this control system and prevents the engine from starting when the control is actuated in forward or reverse. Refer to the
Mercury Precision Parts/Quicksilver Accessories Guide.
The digital throttle and shift (DTS) system required to operate this engine package provides start and stop functions, throttle
control, shift control, start in gear protection, and emergency lanyard stop functions. The DTS system works with specialized
helm components such as a command module kit and electronic remote control. Consult your dealer for a description and/or
demonstration of your remote control.
90-8M0128976
MAY 2017
eng
b
Section 1 - Getting to Know Your Power Package
c
5656
a -
Shift lever
b -
Throttle lever
c -
Trim/tilt switch
Page 9
Advertisement
Table of Contents
